单项选择题
Your company has an IPv4 Ethernet network.A router named R1 connects your segment to the Internet. A router named R2 joins your subnet with a segment named Private1. The Private1 segment has a network address of 10.128.4.0/26. Your computer named WKS1 requires access to servers on the Private1 network.
The WKS1 computer configuration is as shown in the following table.
Network Addresses
IPv4 Address 10.128.64.113
Subnet mask 255.255.252.0
Default Gateway 10.128.64.1
The routers are configured as shown in the following table.
Router ID Addresses
R1
interface 1
R1
interface 2 (To Internet)
10.128.64.1
131.107.108.37
R2
interface 1
R2
interface 2
10.128.64.10
10.128.4.1
WKS1 is unable to connect to the Private1 network by using the current configuration.You need to add a persistent route for the Private1 network to the routing table on WKS1.
Which command should you run on WKS1？（）
A. Route add -p 10.128.4.0/22 10.128.4.1
B. Route add p 10.128.4.0/26 10.128.64.10
C. Route add p 10.128.4.0 mask 255.255.255.192 10.128.64.1
D. Route add p 10.128.64.10 mask 255.255.255.192 10.128.4.0
相关考题
-
多项选择题
Your network uses IPv4. You install a server that runs Windows Server 2008 R2 at a branch office. The server is configured with two network interfaces.You need to configure routing on the server at the branch office. Which two actions should you perform？（）
A. Install the Routing and Remote Access Services role service.
B. Run the netsh ras ip set access ALL command.
C. Run the netsh interface ipv4 enable command.
D. Enable the IPv4 Router Routing and Remote Access option. -
单项选择题
You have a DHCP server that runs Windows Server 2008 R2. You restore the DHCP database by using a recent backup.You need to prevent DHCP clients from receiving IP addresses that are currently in use on the network. What should you do？（）
A. Add the DHCP server option 15.
B. Add the DHCP server option 44.
C. Set the Conflict Detection value to 0.
D. Set the Conflict Detection value to 2. -
单项选择题
You have a DHCP server that runs Windows Server 2008 R2. The DHCP server has two network connections named LAN1 and LAN2.You need to prevent the DHCP server from responding to DHCP client requests on LAN2. The server must continue to respond to non-DHCP client requests on LAN2. What should you do？（）
A. From the DHCP snap-in, modify the bindings to associate only LAN1 with the DHCP service.
B. From the DHCP snap-in, create a new multicast scope.
C. From the properties of the LAN1 network connection, set the metric value to 1.
D. From the properties of the LAN2 network connection, set the metric value to 1.
